Prepare and test your skills
Prepare and test your skills
Free sample question, answered and explained below. The Professional Cloud Architect practice bank has 2,335 more like it. Try 10 free: instant score, no account.
An enterprise is designing a secure hybrid networking solution to connect their on-premises data center to a Google Cloud Virtual Private Cloud (VPC) network over the public internet. The architecture must satisfy the following technical requirements:
How should the Cloud Architect implement this hybrid network connectivity?
Cloud HA VPN is Google Cloud's high-availability VPN solution that provides a 99.99% service level agreement (SLA) by utilizing two distinct public IP interfaces across separate gateway hardware. Combined with Cloud Router, it enables dynamic route advertisement and stateful route failover between on-premises networks and VPCs using Border Gateway Protocol (BGP).
169.254.x.x), both IPv4 and IPv6 reachability information are exchanged across the same session, utilizing configured IPv6 next-hop addresses for IPv6 packet forwarding.This solution uses native Google Cloud networking services that fully support dual-stack routing over IPsec tunnels without requiring GRE overlays or static routing overhead.
This configuration attempts to establish dual independent BGP sessions (one over an IPv4 link-local address and one over an IPv6 link-local address) on each individual HA VPN tunnel to exchange IPv4 and IPv6 prefixes separately.
IPv6 next hop policy statement is attached to the existing IPv4 BGP neighbor configuration.Google Cloud HA VPN architecture required separate network layers for control plane peering and did not support MP-BGP over IPv4 peering addresses.
Classic VPN is Google Cloud's legacy VPN implementation that supports static route-based or policy-based (traffic selector) IPsec tunnels configured with static routing in the VPC routing table.
The workload only required IPv4 traffic, did not need dynamic BGP routing, and connected to legacy third-party hardware that only supported static route definitions.
This configuration attempts to use Cloud HA VPN with the legacy IKEv1 protocol while bypassing dynamic BGP route exchange in favor of manual static route entries.
The scenario involved legacy point-to-point connections where dynamic routing was forbidden by corporate policy and IPv6 support was not required.
Answer them yourself and get your score the moment you finish. No account needed.
Full access includes
Keep the momentum going with these hand-picked practice scenarios
Last updated Validated